Collars and Clamps
These parts are sized to fit our split hub gears and pulleys, allowing you to repeatedly remove or adjust your part's position on a shaft. Parts are available in several styles, with reduced clearance and balancing options for demanding applications.
These clamps allow you to apply pressure by tightening 4 set screws spaced radially along the outside of the part.
EP's set screw collars are convenient for locating and retaining components on a shaft. Use the set screw to hold the collar's position, a small recess is located 90° from the screw as a start for a drill; you have the option of drilling through the collar and shaft to install a pin for the best results.
This is a heavy duty clamp design when higher holding forces are required.